Search results

Hello my question is, I believe the gear oil for the rear differential was orginally 75 90w and then later it was changed to 75 140w but would it be ok for me to run 85 140w. Thanks for your help

I have a 2001 Explorer 4dr 4x4 4.0L SOHC Vin E that has the 5R55E Transmission in it and my question is, Can i replace it with a 2008 Ford Ranger 4x4 tranny that is a 5R55E. If anybody knows the answer or can direct me in the right direction so i can find the answer to this question it would...

Thanks for the info. I am also needing to know since i am replacing my evaporator and condensor coils along with my compressor,accumulator and hoses and my system says it takes 8 ounces of PAG 46 oil should i just get a can of the liquid and pour half of it in the compressor both holes on the...

Anybody have the fuse location on a 2001 explorer XLS for the airconditioning for the relay that kicks the compressor clutch? Thanks

Yeah I already checked any fuses and the relay, the fuses are good and the relay is working perfectly but something is keeping 12 volts from kicking the compressor clutch and i've checked everything. but after reading some posts in the forum it looks like i'm going to have to replace everything...

Alright HELP I have a 2001 Explorer 4d 4wd Vin E 6cyl 4.0 SOHC and I have been working on the air conditioning and I have replaced the Orifice tube and it was extremely dirty and i have metered both switchs and the high pressure cut off switch is normally closed like it should be and the...

I need a 2001 Ford Explorer XLS Dash Instrument Cluster, My instrument cluster is not digital on the mileage it is just the analog dial numbers that add up the mileage. Just had to put another engine in that has 67,000 miles on it but that is not why i'm replacing it, i am replacing it because...

Hello I am looking for a 2001 Ford Explorer XLS 4Dr 4x4 4.0 liter SOHC Motor With the 8th digit in the Vin # being the letter E. I believe it is a one year engine and can only be replaced by the same year and the Letter E in the vin # is a must. Let me know if anybody can hook me up with...

Hey just checking back with you to see if you had a praire tan arm rest lid with mounting bracket and cup holder that slides out the back of the arm rest lid. Thanks Tony

Hey thanks for getting back to me. Yes i need the step bar part and I need the short console. Thanks

Hey I actually need the lid that has the built in cup holders that slide out the back of the arm rest but it need to have the included swivel bracket that mounts to the console Thanks

Got a Factory set i believe of nerf bars for a 2001 explorer XLS that on the passenger one the part by the right rear tire that turns underneath the vehicle broke off and looking for a replacement. nipits@gmail.com

Looking for a Tan console for a 2001 explorer, I really just need the arm rest that has the double cup holder that slide's out the back of the arm rest for the back seat. Need arm rest with mounting bracket that mounts the arm rest.

Looking for a Prairie Tan Center sole with arm rest lid. Mine is broken and need to replace it. Also looking for an End Cap piece to the passenger nerf bar that curves in right in front of the right rear passenger back door. nipits@gmail.com

Yep sent you an email cause i need them and asked you if you might have any of the other parts i need.

Hi I have a 2001 explorer XLS that had the cheap grey molded plastic trim all the way around the suv around the wheel wells and at the bottom of the sides of the suv and also on my 4 door their is a small piece on each of the rear doors. I am in desperate need of the piece that runs along...