Search results

Ended up being a short in the eec and fuel pump relays all i did was tough them and everything turned on!! Its probably because they were cheap heater blower relays from oreileys they could only find that one as one that was similar.

Yeah no noise from fuel pump!! Going to check inertia switch right now!

Alright so i waited till my tank was half way added seafoam and filled up. Drove around town made a few stops. Now my 94 wont start!!! It sounds like its not getting fuel to turn over or something!! Its driving me bonkers!!! At least were here with the kids at my sisters!!

Any discussion on truck claws I don't wanna waste money and the vide are very convincing???

Anyone Heard of Turckclaws???

Got it all off changed both sides had to bang and chisel off the head of the bolt the first side then jut used grabber heads on the next side. Changed my inner and outer tie rods while i was down there. Next in order is coolant lines and manual hubs. Heres a question though after changing all...

https://drive.google.com/open?id=0B7FYuBZU4nIMRjFJWnFLYi0tZWs The smaller one on the right correct? Sucks the bolt on the sensor wire is also stripped

So i dont need to mess with the little bolt in the corner just the one on the sensor that goes through the spindle??

Lmao i was about to write a bunch a realized what you said. so the sensor has no thread in it ? Hows it affect that sensor guard that blocks the spindle from coming off???

And another thankyou for even making this i thought i was stuck when i realized i had first gen ball joints this skips 600$ !!!!

Well spent some time getting that 12 point 6mm for the ABS sensor (Oreilys had a set with one) now the damn thing is stripped. What method has anyone done to get it out if stripped????? i also broke one of the plastic rings on the hub asembly the guys at oreilys said they dont make the kit any...