Search results

Hello. I have a 2000 explorer, radio has display but no button lights I see the display board does not drive the button light does anyone know what does thanks

Hello, does anyone know the values of the resistor's on dorman's 586-001 board this part is no longer made and trying to rebuild the one I have thanks for any help on this

i have a 94 explorer that has rough idle and above idle is rough at times it will run smooth than rough has code 412 and 411 with KOER and sometimes with KOEO there is a code 211 some black smoke i had spare parts so swap out just about all senors still no inprovemet not sure what to try next...

i have a 94 Explorer that will over heat suddenly and than will be normal i have replaceed the water pump, thermostat , rad cap it seems to run fine except for the over heating problem

ok when a test tells you to diconnect the pcm and connect a breakout box is there a way to do this test without a breakout box

i have a 94 explorer i have a (code 214 KOEO) the engine starts and seems to run fine i have cleared the code but comes right back what sensor is more liklely to cause this code the camshaft position sensor or the crankshaft position sensor i have both is there a way to check out the sensors buy...

i have a 94 explorer with a A4LD trans i have over drive but no 3-4 shift and a code of 566

i was told that code 214 is a problem with the camshaft position sensor or is it the crankshaft position sensor i have cleared the codes and 214 and 566 come right back it starts up and runs fine

I have a 1994 Ford Explorer Limited with 100,000+ miles. I have three problems, the first problem being i have a severe ping that i have been trying to get rid of for a long time, I have tried de-carbing the engine, different gas, and removed the octang shortening block, None of these have...

can some one tell me about code 566