a

Pulling my hair out at his point, my 2010 explorer has an intermittent compressor issue. works great below about 75 degrees but as the ambient temp warms up the compressor clutch will engage then disengage, frustrating. I have a local mechanic that works primarily on my 97 power stroke and is...

I ****ed my frame up i go through about 6 sets ofnsway link endds a a year a buddy had a 2000 with a bad motor good trans what issues eill o rum intp puyting my motor and ecu into that ride

Went to my lunch spot today. When I left after 30-35 minutes all I got was static from the radio was the first indicator something was wrong. When parked it was on my usual FM station. AM radio was on the display, What? I next looked at the cluster which was showing tire pressure instead of the...

So I know there is a leak in my A/C system. But right now it isn't blowing cold air but when i hooked up a recharge kit it said I was in the green for refrigerant. The cabin air filter has been replaced in the last month and the air filter has been cleaned. Any idea's on what to check. This is...

Driving on regular roads my car will often dip RPM's (ex, drops from 600 to 350ish) when coming to a stop at an intersection. I've had it totally cut out 5 times while coasting to a stop off the highway. I noticed a high fuel trim so I replaced the vaccum hoses. It was from around 10% long term...

Hello all I'm looking to put some A/Ts on my stock 03 xls. I'm planning on keeping them 325 wide, I'm just wondering if a 235/80 will fit or if I'll need a 235/75.

help indentifying the sensor or control module for a 2000 ford explorer xlt i think its the IACat the top of the engine above the intake. there is a a hard plastin tube that goes from the main intake tube to the what i believe is the IAC (idke air control valve) that has 4 screws. but...

I have a 2017 Explorer Sport, and I could smell some burning oil through the vents while sitting at red lights, it was diagnosed as a rear PTU seal leak. I had that seal replaced, but there's still a leak somewhere as I'm getting a small drop on the driveway every other day. I went under the...

Like the title says, has anyone tried an entire gen 3 front clip on a gen 4 body shell? The gen 4 is overall a better vehicle, revised rear suspension, more powerful v8 engine, better trans behind the v8, and a revised interior design, redesigned rear hatch, but they got an ugly front end. I...

Just purchased a 2020 FPIU, that didn't come with the factory Police Engine Idle feature. If possible, what is necessary for it to get it to work on vehicles that came optioned without it. I have the switch with the button on it. But haven't attempted installing it. Any leads would be helpful...

The light on the left is for a non rear wiper equipped Aerostar. The light on the right is for a rear wiper equipped Aerostar.

Motormite/Dorman/Help sell bleeder screws with a built in check valve to make bleeding the brake system a one person job.

The part number from Motormite/Dorman/Help is 47392. The size is 7/32".

This is extra protection for the computer board in an oven.

Accumulator removal in an Aerostar.

This is the inner bar in a door combination lock. The door in the photo is 1-3/8" thick.

Always support the opposite shock with a Vice Grip when replacing lift support shocks.