a | Page 3 | Ford Explorer Forums - Serious Explorations

  • Register Today It's free!

a

  1. A box wrench is removing the bolt.

    A box wrench is removing the bolt.

  2. Testing the thermocouple with a DMM.

    Testing the thermocouple with a DMM.

  3. Tester, DMM, and a thermocouple.

    Tester, DMM, and a thermocouple.

  4. Testing electrical connections on a thermocouple.

    Testing electrical connections on a thermocouple.

    The wire is positive, and the output tip is negative (positive ground) on the thermocouple that was tested.
  5. Two holes punched in a gasket.

    Two holes punched in a gasket.

  6. Small Skil saw cutting a gasket.

    Small Skil saw cutting a gasket.

  7. Punching a hole in a gasket.

    Punching a hole in a gasket.

  8. Hobby knife set, and a cutting board.

    Hobby knife set, and a cutting board.

  9. A larger view of the gasket being cut.

    A larger view of the gasket being cut.

  10. A hammer punching a hole in a gasket.

    A hammer punching a hole in a gasket.

  11. The retaining lock nut with a groove.

    The retaining lock nut with a groove.

  12. Drilling a 1 1/2" hole.

    Drilling a 1 1/2" hole.

  13. Bike with a new inner tube.

    Bike with a new inner tube.

  14. Bike with a flat front tire.

    Bike with a flat front tire.

  15. Break out diagram of a turbo charger.

    Break out diagram of a turbo charger.

  16. A4LD valve body with a slap hammer removing the stuck end plug.

    A4LD valve body with a slap hammer removing the stuck end plug.

  17. A4LD valve body with a screw in the stuck end plug.

    A4LD valve body with a screw in the stuck end plug.

  18. A4LD valve body with a brake adjusting tool behind the stuck end plug.

    A4LD valve body with a brake adjusting tool behind the stuck end plug.

    I put this tool in this place to prevent the drill bit from going too far into the bore when the drill bit goes through the end plug.
  19. A4LD valve body end plug with a hole drilled into it for a slap hammer.

    A4LD valve body end plug with a hole drilled into it for a slap hammer.

    This is the end plug from an A4LD which was stuck in the bore. I had to drill a hole in it to attach a slap hammer.
  20. High current relay schematic for a dual battery system.

    High current relay schematic for a dual battery system.

    This schematic diagram explains how to use a high current relay instead of a diode style isolator for a dual battery set up.
  21. Supplies for soldering a drain plug into a pan.

    Supplies for soldering a drain plug into a pan.

  22. A4LD pan without a drain plug.

    A4LD pan without a drain plug.

  23. Converted utility tub with a drain valve, and a water filter.

    Converted utility tub with a drain valve, and a water filter.

  24. Converted utility tub with a cartridge circulator pump.

    Converted utility tub with a cartridge circulator pump.

  25. Ridgid 27018 model 2006 tightening a stainless steel flexible line.

    Ridgid 27018 model 2006 tightening a stainless steel flexible line.

Back
Top