a | Page 2 | Ford Explorer Forums
  • Ford Explorer Community - Maintenance - Modifications - Performance Upgrades - Problem Solving - Off-Road - Street

    Explorer Forum Covers the Explorer ST, Explorer Sport, Explorer Sport Trac, Lincoln Aviator,
    Mercury Mountaineer, Mazda Navajo, Ford Ranger, Mazda Pickups, and the Ford Aerostar

    Register Today It's free!

a

  1. 1995 Mass Air Flow (MAF) with a block off plate.

    1995 Mass Air Flow (MAF) with a block off plate.

    • BrooklynBay
    • Media item
    • 1995 a air block flow maf mass off plate with
    • Comments: 0
    • Category: General Photo Album
  2. Air Charge Temperature Sensor in a 1995 3.0L Aerostar.

    Air Charge Temperature Sensor in a 1995 3.0L Aerostar.

    This sensor is screwed into the upper intake manifold. It measures the temperature of the air going into the engine.
    • BrooklynBay
    • Media item
    • 1995 3.0l a aerostar air charge in sensor temperature
    • Comments: 0
    • Category: General Photo Album
  3. Front disc brakes on a rear wheel drive exploded view.

    Front disc brakes on a rear wheel drive exploded view.

    • BrooklynBay
    • Media item
    • a brakes disc drive exploded front on rear view wheel
    • Comments: 1
    • Category: General Photo Album
  4. Gauge with a brass tee.

    Gauge with a brass tee.

    • BrooklynBay
    • Media item
    • a brass gauge tee with
    • Comments: 0
    • Category: General Photo Album
  5. Blow gun with a rubber tip.

    Blow gun with a rubber tip.

    • BrooklynBay
    • Media item
    • a blow gun rubber tip with
    • Comments: 0
    • Category: General Photo Album
  6. Air hose connected to a brass tee.

    Air hose connected to a brass tee.

    • BrooklynBay
    • Media item
    • a air brass connected hose tee to
    • Comments: 0
    • Category: General Photo Album
  7. Air cleaner too with a 1/8 inch pipe tap.

    Air cleaner too with a 1/8 inch pipe tap.

    • BrooklynBay
    • Media item
    • 1/8 a air cleaner inch pipe tap too with
    • Comments: 0
    • Category: General Photo Album
  8. A single frame of weatherstrip.

    A single frame of weatherstrip.

    • BrooklynBay
    • Media item
    • a frame of single weatherstrip
    • Comments: 0
    • Category: General Photo Album
  9. A hole is made for the locking pin.

    A hole is made for the locking pin.

    • BrooklynBay
    • Media item
    • a for hole is locking made pin the
    • Comments: 0
    • Category: General Photo Album
  10. A double frame of weatherstrip.

    A double frame of weatherstrip.

    • BrooklynBay
    • Media item
    • a double frame of weatherstrip
    • Comments: 0
    • Category: General Photo Album
  11. Apply a bead of silicone to the base.

    Apply a bead of silicone to the base.

    • BrooklynBay
    • Media item
    • a apply base bead of silicone the to
    • Comments: 0
    • Category: General Photo Album
  12. A bead of silicone is all around the opening.

    A bead of silicone is all around the opening.

    • BrooklynBay
    • Media item
    • a all around bead is of opening silicone the
    • Comments: 0
    • Category: General Photo Album
  13. The hemisphere is used as a template.

    The hemisphere is used as a template.

    • BrooklynBay
    • Media item
    • a as hemisphere is template the used
    • Comments: 0
    • Category: General Photo Album
  14. Aluminum foil tape & a box cutter.

    Aluminum foil tape & a box cutter.

    • BrooklynBay
    • Media item
    • & a aluminum box cutter foil tape
    • Comments: 0
    • Category: General Photo Album
  15. A Rotozip is cutting the top out.

    A Rotozip is cutting the top out.

    • BrooklynBay
    • Media item
    • a cutting is out rotozip the top
    • Comments: 0
    • Category: General Photo Album
  16. Only draw a little ink at a time.

    Only draw a little ink at a time.

    • BrooklynBay
    • Media item
    • a at draw ink little only time
    • Comments: 0
    • Category: General Photo Album
  17. The caliper pin tool has a groove on the handle.

    The caliper pin tool has a groove on the handle.

    • BrooklynBay
    • Media item
    • a caliper groove handle has on pin the tool
    • Comments: 0
    • Category: General Photo Album
  18. A bungee stretch cord is holding the caliper.

    A bungee stretch cord is holding the caliper.

    • BrooklynBay
    • Media item
    • a bungee caliper cord holding is stretch the
    • Comments: 0
    • Category: General Photo Album
  19. Resistance of a new RABS sensor.

    Resistance of a new RABS sensor.

    • BrooklynBay
    • Media item
    • a new of rabs resistance sensor
    • Comments: 0
    • Category: General Photo Album
  20. Resistance of a defective RABS sensor.

    Resistance of a defective RABS sensor.

    • BrooklynBay
    • Media item
    • a defective of rabs resistance sensor
    • Comments: 0
    • Category: General Photo Album
  21. A view of the reluctor ring.

    A view of the reluctor ring.

    • BrooklynBay
    • Media item
    • a of reluctor ring the view
    • Comments: 0
    • Category: General Photo Album
  22. A box wrench is removing the bolt.

    A box wrench is removing the bolt.

    • BrooklynBay
    • Media item
    • a bolt box is removing the wrench
    • Comments: 0
    • Category: General Photo Album
  23. Testing the thermocouple with a DMM.

    Testing the thermocouple with a DMM.

    • BrooklynBay
    • Media item
    • a dmm testing the thermocouple with
    • Comments: 0
    • Category: General Photo Album
  24. Tester, DMM, and a thermocouple.

    Tester, DMM, and a thermocouple.

    • BrooklynBay
    • Media item
    • a and dmm tester thermocouple
    • Comments: 0
    • Category: General Photo Album
  25. Testing electrical connections on a thermocouple.

    Testing electrical connections on a thermocouple.

    The wire is positive, and the output tip is negative (positive ground) on the thermocouple that was tested.
    • BrooklynBay
    • Media item
    • a connections electrical on testing thermocouple
    • Comments: 0
    • Category: General Photo Album
  26. Two holes punched in a gasket.

    Two holes punched in a gasket.

    • BrooklynBay
    • Media item
    • a gasket holes in punched two
    • Comments: 0
    • Category: General Photo Album
  27. Small Skil saw cutting a gasket.

    Small Skil saw cutting a gasket.

    • BrooklynBay
    • Media item
    • a cutting gasket saw skil small
    • Comments: 0
    • Category: General Photo Album
  28. Punching a hole in a gasket.

    Punching a hole in a gasket.

    • BrooklynBay
    • Media item
    • a gasket hole in punching
    • Comments: 0
    • Category: General Photo Album
  29. Hobby knife set, and a cutting board.

    Hobby knife set, and a cutting board.

    • BrooklynBay
    • Media item
    • a and board cutting hobby knife set
    • Comments: 0
    • Category: General Photo Album
  30. A larger view of the gasket being cut.

    A larger view of the gasket being cut.

    • BrooklynBay
    • Media item
    • a being cut gasket larger of the view
    • Comments: 0
    • Category: General Photo Album
  31. A hammer punching a hole in a gasket.

    A hammer punching a hole in a gasket.

    • BrooklynBay
    • Media item
    • a gasket hammer hole in punching
    • Comments: 0
    • Category: General Photo Album
  32. The retaining lock nut with a groove.

    The retaining lock nut with a groove.

    • BrooklynBay
    • Media item
    • a groove lock nut retaining the with
    • Comments: 0
    • Category: General Photo Album
  33. Drilling a 1 1/2" hole.

    Drilling a 1 1/2" hole.

    • BrooklynBay
    • Media item
    • 1 1/2" a drilling hole
    • Comments: 0
    • Category: General Photo Album
  34. Bike with a new inner tube.

    Bike with a new inner tube.

    • BrooklynBay
    • Media item
    • a bike inner new tube with
    • Comments: 0
    • Category: General Photo Album
  35. Bike with a flat front tire.

    Bike with a flat front tire.

    • BrooklynBay
    • Media item
    • a bike flat front tire with
    • Comments: 0
    • Category: General Photo Album
  36. Break out diagram of a turbo charger.

    Break out diagram of a turbo charger.

    • BrooklynBay
    • Media item
    • a break charger diagram of out turbo
    • Comments: 0
    • Category: General Photo Album
  37. A4LD valve body with a slap hammer removing the stuck end plug.

    A4LD valve body with a slap hammer removing the stuck end plug.

    • BrooklynBay
    • Media item
    • a a4ld body end hammer plug removing slap stuck the valve with
    • Comments: 0
    • Category: General Photo Album
  38. A4LD valve body with a screw in the stuck end plug.

    A4LD valve body with a screw in the stuck end plug.

    • BrooklynBay
    • Media item
    • a a4ld body end in plug screw stuck the valve with
    • Comments: 0
    • Category: General Photo Album
  39. A4LD valve body with a brake adjusting tool behind the stuck end plug.

    A4LD valve body with a brake adjusting tool behind the stuck end plug.

    I put this tool in this place to prevent the drill bit from going too far into the bore when the drill bit goes through the end plug.
    • BrooklynBay
    • Media item
    • a a4ld adjusting behind body brake end plug stuck the tool valve with
    • Comments: 0
    • Category: General Photo Album
  40. A4LD valve body end plug with a hole drilled into it for a slap hammer.

    A4LD valve body end plug with a hole drilled into it for a slap hammer.

    This is the end plug from an A4LD which was stuck in the bore. I had to drill a hole in it to attach a slap hammer.
    • BrooklynBay
    • Media item
    • a a4ld body drilled end for hammer. hole into it plug slap valve with
    • Comments: 0
    • Category: General Photo Album
Back
Top