tach

So Here's the deal. My father In-Law brought over his 91 Ford Ranger 3.0 XLT for a simple idle issue. While looking in to it, I found a host of issues that I have resolved with the help of these forums and the interwebs. However, many posts I reviewed did not often end with resolutions or feed...

Just installed an autometer 5" monster tach into my 99 sport. The reading is off, this new tach reads about 1000rpm higher than the factory tach. Anyone else had this problem?

If you have a tach that you think has gone bad just because it is always up around 3000 rpm? It's not busted - just needs some old fashioned TLC... Here goes: You'll need: T-20 and T-15 Torx driver or bit Something to pry the dash trim off Soldering Iron and maybe some solder/flux 1. Start...

I browse through the post here QUITE often , but this is my first post. I greatly appreciate any and all information that i have recieved from this place. There is obviously a lot of knowledge here. There is 1 thing that I am having trouble with that i dont understand and I cant get any good...