My 4.0 SOHC loses power when I push the gas too much. The rpm’s drop as if the rev limiter is kicking in around 2500 rpm+/-. If I drive without a heavy foot it runs fine but from a stop I have to be very easy on the gas. I have disconnected and reconnected the mass air flow sensor and it seemed to run better for a short time then I checked the sensor with a volt meter and the readings were from .9 at idle to 2.5 at about 2500 rpms. If I disconnect the plug from the mass air flow it runs pretty much the same a little bit different at idle. There are no codes when hooked up to code reader.