2000 Ford Explorer Roll Pan

[alseitsinger]

Hey guys, im new to the forum.

I want to get a rear roll pan for my 2000 explorer and from what I can see I need to either fabricate it myself or buy an older model explorer roll pan and work it onto my body.
Both of these ideas sound horrible to me and I was looking for some advice or links to some roll pans for 2000 Explorer XLT.

Any advice is greatly appreciated..

 

[alseitsinger]

bump

 

[vroomzoomboom]

look at the link in my signature. 98 is the same as a 00. that and the curve on a sport groud effect is the same as the filler panel on all other explorers.

 

[alseitsinger]

So your saying that I wouldnt have to jimmy it into place if I got the roll pan from CanDo for a 98 expo sport?

 

[vroomzoomboom]

i couldn't tell you, i made mine from scratch. besides, and i am not putting you down as i say this, but i have more pride in saying that i built something, rather then buying it, and bolting it on.

 

[alseitsinger]

yeah no doubt my man, but i dont think i have enough talent to do what you did.

 

[vroomzoomboom]

honestly, if you can cut cardboard, and tape it together, you can make this. the difference is, the cardboard is metal, and the tape is a wielder. you work the metal, don't let the metal work you. also, one other nice thing about metal is, if you make a mistake, you can weld in another part. the hardest part of the hole thing was matching the curves to the ground effects (the part that i had to heat, weld, and hammer).

 

[alseitsinger]

a possible summer project.. thanks again