Slicer89
Active Member
- Joined
- February 20, 2014
- Messages
- 67
- Reaction score
- 0
- City, State
- Montucky.
- Year, Model & Trim Level
- 2000 Explorer XLT V8 AWD
After many issues with my 2000 V8 AWDs output speed sensor, I going to start looking into the wiring. My question is, I found a PCM pin-out diagram for it. I also found the pin for the OSS, I am wondering... Does that go directly to the sensor... Or to another computer or relay, or what? And there is two wires on the sensor connector.... But only one going to the PCM. So is one a ground that goes to the chassis, battery or another computer? If the wire test being bad, I might make a temporary jumper wire to get it working. But unsure since there are two wires coming off sensor, but one going to the pcm.