2002 Explorer XLT with transmission codes after a rebuild.

[hpd112]

i just had the transmission rebuilt(had the blinking O/D light) while the trans was going out the speedo started to not work. Now that the rebuild is done(by someone i trust and done transmissons for me before)

im getting codes
P1808
4WD low indicator circuit failure
U1041
U1123
C1284
what are they and what would cause them... and a fix maybe.

thanks jeremy

 

[Sams01XplrSprt]

welcome

 

[BrooklynBay]

Welcome to this forum! I've renamed, and moved your thread into the transmission & transfer case section. Check the internal wiring harness, and the bulkhead connector.

 

[hpd112]

Welcome to this forum! I've renamed, and moved your thread into the transmission & transfer case section. Check the internal wiring harness, and the bulkhead connector.

is the bulkhead on the fire wall, the 3 black squares, and have you heard of having to replacing the cluster to fix the problem?

 

[BrooklynBay]

The bulkhead connector is outside of the transmission. This is where the internal & external wiring harnesses meet.

 

[hpd112]

i just noticed that when i turn the truck on, the volts, oil pressue, temp gages all go to DEAD nuts center... and dont move at all?

 

[BrooklynBay]

Did you check your charging system?