32x11.5 on '92 w/2" lift?

[Mulepick]

I've got a Skyjacker 2" lift on my '92 (bigger springs, helper leafs) and have been running 31x10.5s with no problem.

It looks like I could step up to 32x11.5s but I'm wondering if anyone has tried this before I buy. Shouldn't make any difference but I'm running Bushwacker fender flares and Helwig HD sway bars. I'm also presuming that OEM wheels (15") will handle the 11.5 width OK.

Thanks,

Bob

 

[kvo]

I have the Rancho 2.5" lift and running 32". I had to trim the fenders and also the radius arms (Rancho's) to clear the rubbers under full turn and compression. A lot of work because it's a trial and error process. You don't want to go too far into the flange of the radius arms so I had to do it over and over. Still some more minor grinding this weekend.

I also have the Bushwacker extend a flare and the two front ones have to be trimmed back a bit at the inside bottom.

BTW, I have a 4DR 91 EB.

[This message has been edited by kvo (edited 01-07-2000).]

[This message has been edited by kvo (edited 01-07-2000).]

 

[Shaggy]

I have the 2" Skyjacker lift and run 31's. 32" Swampers fit, 32" BFG's did not. I drove around on the Swampers, but the BFG's would not turn w/o major problems. All tires were on at least 15x8 inch rims, though. My 31's rub the top of the wheel wells when I punish them, but fit fine on the street. 15x7's are a little on the small side for 32x11.50's, but should work.