4x4 not working

[JTX]

Here's the lock out kit on napa.

http://www.napaonline.com/masterpag...mber=6301653&Description=Spindle+Lock+Nut+Kit

You would need 2 of these. There from a Dana 44 but are the EXACT same thing at a fraction of the cost.

 

[energie]

haha damn that ebay item was shipping only to the lower 48 states
and i was looking for something newer, no?
i dont know if it matters or not. i saw some on 4wheelonline for 177 i think.
and that spindle and nut kit goes inbetween the axle shaft and the hub or what?

 

[Robrt32]

I paid 174 for the Warn Hubs and 40 for the conversion kit, 25 for the socket at Advance Auto parts yesterday...

 

[JTX]

Here's a pretty good break down.

http://www.therangerstation.com/tech_library/howto_hubswap.htm


As for hubs, used ones will work fine. Just put a little fresh grease in them and your set.

 

[energie]

what kind of socket do you use? and thats not too bad, thats a good breakdown
looks kinda technical though lol

 

[JTX]

You have to get a costom one. Its like $14 at most stores. I used a chisel and a hammer when i didnt have one. Works, but not as well.

 

[DeRocha]

I bought my Warn manual hubs from Ebay as well..

You can pick up both hubs and install kit for <$200

Warn Hub kit on Ebay

 

[coheed]

Keep your eyes peeled on ebay. I found a set of good used Warn hubs for 70 bucks shipped, and bought the conversion kit at AutoZone for 34.99 (I think).

Here's a link to a few good sets for less than $150...
http://shop.ebay.com/?_from=R40&_trksid=m38.l1313&_nkw=explorer+manual+hubs&_sacat=See-All-Categories