A4LD install might of screwed up

[igiveup]

Hello

Yesterday when I was done installing my A4LD I noticed when I tightened up my tourqe converter it suck up to my flex plate by another 1/4 inch. They were in the holes before I started it. Did I screw up?

igiveup

 

[mechjames]

i'd like to know the answer to this question because i'm doing this on tuesday.

but I think that might be the way its designed, you might have had the torque convertor back too far, and it is still probably on the shaft spine.

 

[igiveup]

Hello

Anyone else have an answer. I would like to put everything else on today and go and play.

igiveup

 

[BrooklynBay]

It doesn't sound like you did anything wrong. Did you turn the torque converter into the bell housing completely prior to installing it? Does the engine turn over by hand with a ratchet or a breaker bar without binding?

 

[igiveup]

Hello

The only time it gets stiff is when its on compression stroke. I can hear it compressing. Well I pray I did this right otherwise if this thing blows up I won't be able to play till late summer or later.

igiveup

 

[igiveup]

Hello

Well all seems good. Took the B2 down all over town and some quad trails today. Works good and shifts awesome now.

igiveup

 

[BrooklynBay]

Thanks for the update!