Abs rear sensor

[Bugmanovski]

Having problems with my ABS. Replaced rear sensor twice but still problems. Measured ohm and it is 200 kohm at control module. I have visually checked cable but can't see any problems. Any idea how to go forward?

Also I have measured voltage on connector. It is 12 volts on pin 19 and 20 and 7,5 volt on pin 17. Is that correct?

 

[EXPLORER04]

What are the ABS codes?

 

[BigRondo]

I will check my shop manuals when I get home tonight for any pertinent information.

Stand by...................

 

[Bugmanovski]

Problem solved. The code was C1185 abs power relay and I was told to replace control unit wich I did but it did not solve the problem. Abs light was still on. I measured ohm on all wires. One wire to rear sensor was very high ohm. Checked wire and found small hole in the isolation (the plastic surrounding wire) . The wire inside was completely black and easy to break. Had to replace about 12 inches of the wire and....TADAHHH! ABS is functional!

Now having a whiskey thanking all help from this forum...thanks a lot!!!