Aftermarket PLUG WIRES- who makes them - 5.0

[PUR PONY]

I am fed up with the factory ford exploer 5.0 V-8 plug wires.

Does anyone have aftermarket plug wires and who makes them???

I was looking for a 9mm instead of the factory 8mm also.

any help would be great

 

[Okrazie1]

Magnecor makes a set of 8.5mm wires for your '96 (p/n 85230). They run about $125, however.

 

[aldive]

Jacobs also makes good wires. Tajke a look at Dead Link Removed

 

[dondiesel444]

Just today I had to replace my plug wires AGAIN!! A few months ago I installed a set from NAPA (Belden), and yesterday one of them got too close to the drivers side frontmost header and it melted in half. NAPA would not replace them (they had a lifetime warranty) b/c they said it was my fault, not a factory defect.

Anyways today I picked up a set of Autolite Pro-fit wires, they are a very nice set, much higher quaility than the stock and the NAPA wires. They cost me $75, they come with heat sheilding as well, and also have a lifetime warranty (expect if they melt I assume!!!). Oh yeah, they are also 8.5mm wires. I am impresed with them so far...

good luck!!

 

[5.0Dad]

Holley has some. They are a 50 ohm, 9mm set called Laser Shot 50. Got mine through Summit but they're not listed in the catalog. The fit list is at:

http://www.holley.com/HiOctn/ProdLine/Products/IS/ISLSSPW/LS50Csuv.html