Anyone cut fuel pump access panel on 5th gen?

[Thunder1992]

Looking for where to cut. I've done this on my bronco with zero regrets. Anyone?

 

[peterk9]

Using the handy Search feature, top right, I found this thread;

LPFP hanger assembly access for DW300c Fuel Pump install

So I was really dreading installing the fuel hanger that had installed the DW300c into. https://www.explorerforum.com/forums/threads/installation-of-deatschworks-dw300c-fuel-pump.486828/ Reason being...I was dreading dropping the fuel tank as we don't have top access from within the vehicle...

www.explorerforum.com

Peter

 

[Thunder1992]

Using the handy Search feature, top right, I found this thread;

LPFP hanger assembly access for DW300c Fuel Pump install

So I was really dreading installing the fuel hanger that had installed the DW300c into. https://www.explorerforum.com/forums/threads/installation-of-deatschworks-dw300c-fuel-pump.486828/ Reason being...I was dreading dropping the fuel tank as we don't have top access from within the vehicle...

www.explorerforum.com

Peter

Thanks!

 

[Steve8316]

I wouldn't cut the carpet - it's too easy to lift out of the way intact. And I wouldn't cut the odd-shaped hole he did - only a simple rectangle, maybe just around those 2 humps. And I'd use self-tapping sheet metal screws and gum sealant (TackyTape) like I include with the Bronco kits that I sell.

This is how my floor looked when I swapped rear seats & carpet a few weeks ago: