Aux input cable

[evanseptember]

Anyone have a link we're I could find an aux input wire that would work with a 2015 pui without sync I've been looking but couldn't find one that I was confident in working

 

[ProjectSHO89]

Any 1/8" 3-wire cable should work. There's nothing special beyond that. You can buy them at Walmart or Amazon. Probably the corner gas station or convenience store.

 

[mrdot]

correct, you don't need buy that premade cable. you will also need to edit the settings in forscan to enable.

it seems like that guy, jmr passed away last June.

 

[TwoEcho27]

correct, you don't need buy that premade cable. you will also need to edit the settings in forscan to enable.

it seems like that guy, jmr passed away last June.

Will that work on a 2016+?

 

[mrdot]

yes, add aux jack and the bezel (BT4Z-19C149-B) then inject to 2 pins into the back of the acm and edit the fcdim setting in forscan. very easy.

 

[firemedicjoe]

Anyone have a schematic on how to wire it?

 

[goots]

If you have the wiring for it, you can get the CV6Z-19C149-A bezel with the AUX and USB.

 

[DHG2496]

@firemedicjoe If you're looking for a quick and easy solution to add a jack, there was a post on the Interceptor Facebook Group linking to a pre-made cable with pins and includes instructions on where the pins go. It's only $15 and on Facebook it said if you use coupon code FORD it gave you $5 off. I've never used this so can't vouch for the product but just saw this the other day and I have not affiliation with the product.

AUX Harness - Ford Police Interceptor w/o SYNC | ATO - Auto

Options: AUX Harness +Aston Innovations Bluetooth Adapter +FORScan ELM327(Entry Level USB to OBDII Adapter for use with FORScan) Simply enable the Media button using FORScan, plug the 4 pins into the back of the APIM Connector, and you will have successfully added AUX Input to your Ford Police...

www.ato-auto.com

I also wrote up a post about this when I did mine and have been documenting some of the modifications I've done. Enabling AUX Input

 

[Stem]

yes, add aux jack and the bezel (BT4Z-19C149-B) then inject to 2 pins into the back of the acm and edit the fcdim setting in forscan. very easy.

Hey, I didn't see a reply here, are you replying that this AUX pin config will work on a 2016+?

AllData shows the audio jacks being controlled by the SYNC module and I do not have one.

 

[mrdot]

sync isn't needed for adding just AUX. should work the same 13-19.