S
shaggsta
I have a good deal on an 89 Bronco II Tcase and related parts to swap into my 1992 X. It is a manual shift and since my electric shift doesn't work, I figure why not. Is it the sme T Case? Will it fit without mods?
-
Performance Upgrades - Maintenance - Modifications - Problem Solving - Off-Road - Street Trucks.
Covering the Explorer, ST, Sport, Lincoln Aviator, Sport Trac,
Mercury Mountaineer, Mazda Navajo, Ford Ranger, Mazda Pickups, and the Aerostar.
Featuring H.I. - Human Intelligence.
Register Today It's free!
bmxking5
Explorer Addict
- Joined
- May 2, 2004
- Messages
- 4,759
- Reaction score
- 4
- City, State
- Monroe, GA
- Year, Model & Trim Level
- '93 Sport & '96 XLT
This link has a lot of info on what t-cases fit and the parts needed.
http://www.explorerforum.com/forums/showthread.php?s=&threadid=46237
http://www.explorerforum.com/forums/showthread.php?s=&threadid=46237
The BII used the BW1350 case (except in '90 I believe), whereas your X uses a BW1354.
The main difference between the two is that the 1350 uses a splined output to the front driveshaft, while the 1354 uses a u-joint yoke.
My guess would be that you could use it, if you also used a Ranger or BII front shaft (splined), but don't quote me on that.
edit: yea, that link is much better than my yapping!
The main difference between the two is that the 1350 uses a splined output to the front driveshaft, while the 1354 uses a u-joint yoke.
My guess would be that you could use it, if you also used a Ranger or BII front shaft (splined), but don't quote me on that.
edit: yea, that link is much better than my yapping!
Featured images
Featured images
