stephan325i
Well-Known Member
- Joined
- October 6, 2007
- Messages
- 141
- Reaction score
- 1
- City, State
- Oshkosh Wisconsin
- Year, Model & Trim Level
- 1985 Bronco II, 2.8, 5spd
So heres the deal, i have a 4.0 OHV out of a 1995 ford explorer that i planned on swapping into my BII after i found the 4r44e to put in with it. When the time came i planned on doing a complete swap including dash, HVAC, all wiring harnesses (including body harness minus speakers and electric windows and locks, and the complete wiring harness from the engine bay including headlights and all.) rear axle, transfer case, etc. basically everything but the body. Am even using the seats and center council. It was going to make the job easier to just put it all into the BII.
Well heres the problem, i blew a head gasket in my BII tonight driving back to oshkosh, wi, and i need it running, its my only vehicle. So the question is...
What is it going to take to put just the engine and engine wiring harness into the BII? is this going to be possible or does this engine require the wiring under the dash for the engine to run?
Any help ASAP would be appreciated.
Oh and thank god for elite status. Well worth it for this post alone if my problem gets solved. Thanks in advance.
Well heres the problem, i blew a head gasket in my BII tonight driving back to oshkosh, wi, and i need it running, its my only vehicle. So the question is...
What is it going to take to put just the engine and engine wiring harness into the BII? is this going to be possible or does this engine require the wiring under the dash for the engine to run?
Any help ASAP would be appreciated.
Oh and thank god for elite status. Well worth it for this post alone if my problem gets solved. Thanks in advance.