Roberth78
Member
- Joined
- March 5, 2014
- Messages
- 26
- Reaction score
- 0
- City, State
- Southern California
- Year, Model & Trim Level
- 2014 Ford Explorer XLT
Hey everyone, so I think I'm going to attempt this ambient lighting that I was asking about last week. I was able to get some instructions that are pretty straightforward from the dealer. But I have one question, does anyone know where the BCM is? Is it near the elusive fuse box?
It gives what wire to connect to etc, but I just can't seem to figure out what a BCM is. I know it has to do with communications of the car etc, but don't know what it LOOKS like. And what I should be looking for.
The instructions say to remove the steering column panel and that new black cover plate underneath it, that seems to have appeared on newer models. So I assume it's somewhere in there, near that fuse box location... Anyone have any idea?
Below is a copied instruction line from the actual instruction document that I was sent...
32. Identify the Yellow/Green parking light circuit wire at the body control module (BCM) connector C2280D pin 18.
33. Connect the White wire from the ambient lighting harness to the Yellow/Green parking light circuit wire at the BCM connector C2280D pin 18.
Any ideas or suggestions would be much appreciated.
It gives what wire to connect to etc, but I just can't seem to figure out what a BCM is. I know it has to do with communications of the car etc, but don't know what it LOOKS like. And what I should be looking for.
The instructions say to remove the steering column panel and that new black cover plate underneath it, that seems to have appeared on newer models. So I assume it's somewhere in there, near that fuse box location... Anyone have any idea?
Below is a copied instruction line from the actual instruction document that I was sent...
32. Identify the Yellow/Green parking light circuit wire at the body control module (BCM) connector C2280D pin 18.
33. Connect the White wire from the ambient lighting harness to the Yellow/Green parking light circuit wire at the BCM connector C2280D pin 18.
Any ideas or suggestions would be much appreciated.