dash wiring for 4406 swap

[audiodude332001]

Just finished my manual 4406 swap yesterday and cant find what wires I need to tie into for the 4x4 lights on the dash. Any help would be great.

 

[albi1cnobi1]

Light blue/black on pin 2 of cluster harness for 4lo and grey on pin 3 for 4hi. However since you had AWD the wires may not be there. If not just find the 2 bulb locations, one side is hot(+12v) all the time and the other side will go to the respective wires from the t-case.

 

[audiodude332001]

Light blue/black on pin 2 of cluster harness for 4lo and grey on pin 3 for 4hi. However since you had AWD the wires may not be there. If not just find the 2 bulb locations, one side is hot(+12v) all the time and the other side will go to the respective wires from the t-case.

Yea I tried the light blue/black,and the grey wire before creating this post. Will probly end up tearing the cluster out and going from there