Drive Shaft U-Joint p/n???

[ptf18]

Fellows: I'm planning on replacing the U-Joints in my 2002 S/T 2 WD Driveshaft (I piece aluminum tube).

I'm finding conflicting information about correct part numbers and would like to ask those that have replaced them (both transmission and differential ends) what they found to be the correct part numbers.

Thanks,

ptf18

 

[koda2000]

Here's one that AutoZone lists for the 2WD. Say's it fits front and rear of the driveshaft. There was also a less expensive one listed.

http://www.autozone.com/powertrain/u-joint/moog-super-strength-u-joint/704931_0_4227

 

[Paul Fithian]

Be careful when you install these.

I had to grind a few thousands off of the end of the U-joint bearing caps in order for the snap rings to seat in the yokes properly.

 

[ptf18]

Thanks Fellows. Perhaps its best if I purchase the Ford OEM ones? I would think grinding on the caps may take awhile with the limited access to a grinder.

 

[Lone_Wolf]

Just did mine, ordered ujoints from rockauto. Rented a press tool kit from Advanced auto to remove and install them.