S
Shaggy
I am thinking about loading a stealth type box with a single DVC sub, and need some info from someone who understands this stuff.
- If I wired the two 4 ohm coils in parallel, would I get a 2 ohm load?
- How much power would each coil get with a Fosgate 150a1 (150x1 @ 2 ohms) or a Fosgate 100a2 (100 x1 bridged)?
- Would the DVC set up play louder than a 4 ohm sub with the same amp?
-JL 10w3 or RF DVC 10"?
This is sorta new to me, and I don't quite understand all of the physics involved. I want to get the most boom possible with just one speaker and a small amp. Any info is greatly appreciated.
Thanks
- If I wired the two 4 ohm coils in parallel, would I get a 2 ohm load?
- How much power would each coil get with a Fosgate 150a1 (150x1 @ 2 ohms) or a Fosgate 100a2 (100 x1 bridged)?
- Would the DVC set up play louder than a 4 ohm sub with the same amp?
-JL 10w3 or RF DVC 10"?
This is sorta new to me, and I don't quite understand all of the physics involved. I want to get the most boom possible with just one speaker and a small amp. Any info is greatly appreciated.
Thanks