Rohlo
New Member
- Joined
- October 2, 2017
- Messages
- 3
- Reaction score
- 0
- Year, Model & Trim Level
- 2010 Explorer XLT
2010 explorer 115,000 miles. Late summer started putting out these codes:
P0443 - Evaporative System Purge Control Value Circuit
P0053 - HO2S Heater Resistance (Bank 1, Sensor 1)
P0054 - HO2S Heater Resistance (Bank 1, Sensor 2)
P0059 - HO2S Heater Resistance (Bank 2, Sensor 1)
P0060 - HO2S Heater Resistance (Bank 2, Sensor 2)
P0403 - EGR Control Circuit
I have the Haynes manual for the vehicle so i started with that and looked over all the vaccum lines in the EVAP system that i could find/see. Then i started replacing parts since it does see its fair share of gravel roads. Thought that dust could have a caused a plug. So far i have replaced all O2 sensors, the EGR valve, the canister purge value and the canister vent value solenoid. Found a warranty on the vehicle that was never done took it into the Ford dealer they said that it wasn’t the right codes for the warranty but thought it could possibly be an O2 sensor ground issue. I will not let this dealer touch the vehicle. Terrible reputation and screwed up when even when i asked about the warrranty.
Had it into a local shop for a separate issue he thought that there may be a fuse somewhere that is causing this EVAP issue. I have checked all the fuses and relays and cant find anything that seems wrong. No gas smell when i shut off the vehicle. Fuel mileage is the same as it always has been. Anyone have similiar issues before that they corrected.
P0443 - Evaporative System Purge Control Value Circuit
P0053 - HO2S Heater Resistance (Bank 1, Sensor 1)
P0054 - HO2S Heater Resistance (Bank 1, Sensor 2)
P0059 - HO2S Heater Resistance (Bank 2, Sensor 1)
P0060 - HO2S Heater Resistance (Bank 2, Sensor 2)
P0403 - EGR Control Circuit
I have the Haynes manual for the vehicle so i started with that and looked over all the vaccum lines in the EVAP system that i could find/see. Then i started replacing parts since it does see its fair share of gravel roads. Thought that dust could have a caused a plug. So far i have replaced all O2 sensors, the EGR valve, the canister purge value and the canister vent value solenoid. Found a warranty on the vehicle that was never done took it into the Ford dealer they said that it wasn’t the right codes for the warranty but thought it could possibly be an O2 sensor ground issue. I will not let this dealer touch the vehicle. Terrible reputation and screwed up when even when i asked about the warrranty.
Had it into a local shop for a separate issue he thought that there may be a fuse somewhere that is causing this EVAP issue. I have checked all the fuses and relays and cant find anything that seems wrong. No gas smell when i shut off the vehicle. Fuel mileage is the same as it always has been. Anyone have similiar issues before that they corrected.