aldive
Elite In Memoriam
- Joined
- January 17, 2001
- Messages
- 24,667
- Reaction score
- 28
- Year, Model & Trim Level
- 1999 XLT
I finally got tires of looking at my round 2 ½ inch pipe exiting under the rear bumper and decided to install a stainless steel “exhaust “tip”.
I chose to use a 2 ½ inch inlet x 3 inch angled cut exit tip for the installation.
I tool my Sawsall and cut off 5 inches of the exhaust pipe, slid the new tip in place, and welded it on.
I think it looks better than the plain round pipe that was previously there.
I chose to use a 2 ½ inch inlet x 3 inch angled cut exit tip for the installation.
I tool my Sawsall and cut off 5 inches of the exhaust pipe, slid the new tip in place, and welded it on.
I think it looks better than the plain round pipe that was previously there.