explorer wont stat after intake install

[awd96]

hello i am new to the forum and have a problem with my truck
its a 96 explorer 5.0
i installed a new intake gasket fuel filter plugs wires
the wires are in the right order and i checked im getting spark and fuel but it wont start sometimes when i crank it and hit the gas peddle it will sputter but wont fully start if anyone has some suggestions they would be greatly appreciated

 

[ragajungle]

there are a lot of connectors involved in this - recheck for one you may have not seated correctly.

 

[swetrid]

ck the firing order and all the electrical connectors.

 

[awd96]

this is drivin me crazy checked the firing order and all the conections all good ill be cranking it over and it will sputter for less then a sec several times while cranking kinda like a security problem but i have no security system in the car any other suggestions

 

[1999_sport]

sounds like a vacuum leak somewhere

 

[Spdrcer34]

Did you move/remove the Cam Position Sensor?

Worst case scenerio, you pinched/folded the intake gasket, and you have to re-do it.

Best case scenerio, it's a connector/vacuum line that needs to be connected...

Good luck.

Maybe you could shoot 3-5 CLEAR pictures, with a high-res. camera, and post them here...maybe one of us will spot something out of place.

Ryan