Fuel pump question.

[EB4X]

Neat ! didn't know this tool existed. Lots of options for them on a search. Only spec I could find on any of them was it will cut 14 Ga metal. Not sure if that is heavy duty enough for these floor boards. Have you any experience using one for this purpose. I can't resist a new tool, especially for that kind of money if it works for the purpose. .

I did 90% of my floor board (on my 4 door) with one of these (same one as pictured) ...on my 4 door there is an mini hump/ruffle where I had to break out a angle grinder/cutting wheel for just a couple spots... like 4 inches total....sniffed for fumes first.

 

[Pete Deering]

Neat ! didn't know this tool existed. Lots of options for them on a search. Only spec I could find on any of them was it will cut 14 Ga metal. Not sure if that is heavy duty enough for these floor boards. Have you any experience using one for this purpose. I can't resist a new tool, especially for that kind of money if it works for the purpose. .

Floor are made of 16 gage