HELP! Fuel problem

[BggedRanger]

Well I worked on tracing some more wires friday, and I traced them to the computer. I decided to pull the computer out, and just look at it. Before I even had it all the way out the smell of burnt electronics just about nocked me down. You can see where something on the board arched and burned it up. My new computer should be here some time this week. Thanks for eveyones help. Hopefully this will take care of my problem.

 

[budwich]

wow..... I would check a few things before you plug it in and try and start it. Make sure your ground points are all good. Without seeing the "burn marks", its tough to now what happened but my guess is that it got some current thru on one of these "switched ground points" like that going to the FP relay. Is it possible that you "wire jumped" the wrong terminal on the FP relay when you were playing around???? Ultimately, I hope it works out for you and you are not in using the "PCM module" as a "fuse"... that would be an expensive method...

 

[BggedRanger]

Well guys I got my truck back today after waiting on the computer for about two weeks, that was on back order. So glad to have it back and running. Thanks for everyones help.