How do you take the lens apart?

[Brett F.]

Ok guys. I have seen a couple of projects where the OEM lens was taken apart.

My lights are so dull and I have polished the outside and still no good.

I want to take the lens apart and polish the inside of the lens.

Is there any way to do it?

 

[FexplorerV8]

yeah go on ebay and get clear headlights its the bet investment u can make. i just didi and i love them

 

[Brett F.]

Thanks.

That's what I figure I really need to do.

Not really what I want to do but what I need to just do and get it overwith.

 

[FexplorerV8]

trust me you wont regret it, i tryed just about everything on my lights and nothing worked, its not worth the sweat just get a whole new set u will love how they will look!

 

[Afboy143]

Turn the oven on to 300 degrees F and let it preheat for 10 mins. After that, turn it off and put the housing in for 7 mins. Take it out and see if the lense will come off. If not, preheat the oven again and put in for an additional 5 mins. This is what I did on my diamond cuts to open them up

WARNING: A member on another forum noted that ford headlights melt easily under heat. What kind of heat? Not sure... I would think the above procedure is fine since the oven is not on when the headlights are put in