-
Ford Explorer Community - Maintenance - Modifications - Performance Upgrades - Problem Solving - Off-Road - Street
Explorer Forum Covers the Explorer ST, Explorer Sport, Explorer Sport Trac, Lincoln Aviator,
Mercury Mountaineer, Mazda Navajo, Ford Ranger, Mazda Pickups, and the Ford Aerostar
Register Today It's free!
how to bridge amp?
- Thread starter dazsherm
- Start date
Cartman
Well-Known Member
- Joined
- August 24, 2001
- Messages
- 521
- Reaction score
- 0
- City, State
- Waterloo, Ontario
- Year, Model & Trim Level
- '96 Sport
I'm going to assume you're using a 2 channel amp, what you need to do is take some speaker wire and run it from the + of one channel to the - of the other. Usually it is marked on the amp which terminals to bridge.
leenjen
Explorer Addict
- Joined
- May 6, 2001
- Messages
- 5,344
- Reaction score
- 0
- City, State
- in the poconos, PA
- Year, Model & Trim Level
- 2001 sport
and make sure you dont have it wired at too low of an impedance. if your sub is set up @2 ohms, make sure the amp is stable to 2 ohms mono. most class AB amps are 4 ohm mono stable.
Explorer Features
Explorer Features
