3boydad
New Member
- Joined
- July 1, 2009
- Messages
- 8
- Reaction score
- 0
- City, State
- Yardley PA
- Year, Model & Trim Level
- 03 xlt
I have an '03 XLT that will only go into 4X4 High and 4X4 Low. It will not go into 4X4 Auto. I have replaced the transfer case motor and the 4X4 control module and tried the Brown Wire Mod. I figure it must be a bad sensor that is the problem. I have pulled the TC motor and tried move the tc motor to the 4X4 Auto but I get a loud clicking sound :roll:when I try to put it into reverse and when i put it into drive the transmission does not engage (it is like it is in neutral).
Does anyone have any suggestions on how i can manually put it in 4X4 Auto with the tc motor off. Once I get it in 4X4 Auto I can manually adjust the TC motor to be 4X4 Auto and disconnect it electrically until I resolve the sensor issue
Does anyone have any suggestions on how i can manually put it in 4X4 Auto with the tc motor off. Once I get it in 4X4 Auto I can manually adjust the TC motor to be 4X4 Auto and disconnect it electrically until I resolve the sensor issue