Moog Sway Bay Link Question (K7275)

[Afboy143]

Hey guys,
My stock sway bar links broke so I got some moog replacements. Part K7275. They look like the below

My question is how much do I torque these down to?

 

[techieman33]

15-21 ft/lbs.

 

[Trebor]

just remember after a week or two to retighten them as the bushings become compressed they will give a little and start clunking

 

[Afboy143]

15-21 ft/lbs.

Thank you sir. I actually did them yesterday. I was using a torque wrench set to 19 LBS and I was tightening the bolt and it never got to the 19 LBS point. I finally just stopped because the bushings were becoming so compressed.

Today I noticed going over holes and bumps that the right side makes noise. Do I need to back the nut off a little?