new guy with a problem

[arkokes]

Hello, I have a 02 ford explorer xls, recently my o/d light has been flashing and the shifting from 1st to 2nd is delayed, or I have to let off the gas for it to shift. Pulled the codes and it said pressure control solenoid b. After doing some research, I came up with needed to replace the solenoid block. Did that today, changed the solenoid block, trans filter, and new ATF. Put it all back together, take it for a test drive, and same problem still exists. So I was wondering what else it could be?

Thanks for the help.

 

[arkokes]

doing a bit more research looks like it might be the o/d servo, where can I buy a new one and what are the steps to replace this?

 

[BrooklynBay]

Welcome to this forum! What are the code numbers? You could have a broken band, servo or a worn servo bore.

 

[arkokes]

It's been a few weeks, but i'm pretty sure it was p0775

 

[BrooklynBay]

You could try the aftermarket servo with the O ring. The only other option is to remove & rebuild the transmission, and resleeve the servo bores. The servo with the O ring has good reviews from other members on this site.

 

[arkokes]

Where could I buy that?

 

[BrooklynBay]

http://www.fordservoboretransmissionfixsolution.com/order-page.html

 

[arkokes]

Ouch that's pricey. Just scanned it again and the was p0775.

Would just replacing it with the factory servo fix it?

 

[BrooklynBay]

You can't use a factory servo unless you resleeve the bore first.