accent0002
New Member
- Joined
- September 8, 2007
- Messages
- 5
- Reaction score
- 0
- City, State
- port angeles, washington
- Year, Model & Trim Level
- 94 explorer xlt
Hey I’m wondering if anyone has an idea if you know the 4.0 sohc well what might stop oil from getting to the driver side head? I have good oil pressure at the sensor while cranking 50-60 but no oil getting to tensioner/cam oil tube/lifters
I tore the head off of it today and tryed blowing air through the oil port and nothing goes through. Blow through the sensor port and it goes through to the chain area/pan
My passenger Side head and tensioner is getting oil So it’s just the driver side.
The Engine is basically rebuilt I had just put new bearings, pistons, rings, heads, timing chains on it And cleaned everything when it was apart
Any ideas before it all comes apart again?
I tore the head off of it today and tryed blowing air through the oil port and nothing goes through. Blow through the sensor port and it goes through to the chain area/pan
My passenger Side head and tensioner is getting oil So it’s just the driver side.
The Engine is basically rebuilt I had just put new bearings, pistons, rings, heads, timing chains on it And cleaned everything when it was apart
Any ideas before it all comes apart again?