lponestep113
New Member
- Joined
- September 12, 2005
- Messages
- 6
- Reaction score
- 0
- City, State
- randolph, new jersey
- Year, Model & Trim Level
- n/a
hey everyone...first post on this entire forum
im installing a sound system in my friends 95 explorer. so i ran all the wires....everything went fine. however, once everything was done, and i went to put the door sills back on on the side that i ran the power wire, i discovered that since i used 2 gauge wire, the wire was too thick for hte door sills to fit back on. I tried tucking the wire under the insulation that runs along the door....that didnt work. I tried just banging the door sill down as hard as i could. that didnt work either.
any suggestions??? it would have worked totally fine if the wire wasnt so thick, but the amp definitely requires that i use good wire like this.
so can anyone help me out? any other spot i should run the wire?....even though i'd really hate to redo the wiring.
thanks so much...i appreciate any help you can give me

im installing a sound system in my friends 95 explorer. so i ran all the wires....everything went fine. however, once everything was done, and i went to put the door sills back on on the side that i ran the power wire, i discovered that since i used 2 gauge wire, the wire was too thick for hte door sills to fit back on. I tried tucking the wire under the insulation that runs along the door....that didnt work. I tried just banging the door sill down as hard as i could. that didnt work either.
any suggestions??? it would have worked totally fine if the wire wasnt so thick, but the amp definitely requires that i use good wire like this.
so can anyone help me out? any other spot i should run the wire?....even though i'd really hate to redo the wiring.
thanks so much...i appreciate any help you can give me