Start problem 93 xlt | Ford Explorer Forums

  • Register Today It's free!

Start problem 93 xlt

MrJim206

New Member
Joined
May 10, 2006
Messages
6
Reaction score
0
City, State
Baldwinsville, NY
Year, Model & Trim Level
1993 Explorer XLT
Here's my problem, it had no spark so I had coil pack replaced and found the old one had a crack. It started for four days many times without a problem until today when it did the same thing, no spark again. What else should I look for as a cause? Someone mentioned a starter module, what and where is that located? I'm needless to say irate and could use some help. It's a 4.0 2wheel drive. Any help would be appreciated.
 






I think your asking about the ignition module, which is near the passenger headlight (you need to pull the battery to get to it)..

~Mark
 






Mark, thanks for the location, I noticed a condensor on the side of the coil pack that looks pretty rusty, could that be a cause too?
 






As far as I know, no.. a bad consensor won't make for no start.. It would just put more noise into the radio etc..

Since your not getting spark, also check the crank sensor.. w/out it it won't fire...

I'm sure other people will chime in with suggestions..

~Mark
 






Featured Content

Back
Top