Torque specs

[modest89]

Hello all!
I've been searching up and down and cannot for the life of me find torques specs for my 2000 explorer 2dr sport 4.0 ohv with manual m5r1. I need torgue tightening specs for the flywheel bolts, pressure plate bolts, retainer for front trans shaft bolts, rear tailhousing to trans body bolts, transfer case to tailhousing bolts, Trans mount bolts, front and rear driveshaft bolt (all), and starter bolts. If anyone could help I would really appreciate it. Im in Colorado and unfortunately my book is in Texas....

 

[rb142]

flywheel bolts: 75-85 ft-lbs
pressure plate bolts: 24 ft-lbs
retainer for front trans shaft bolts: 12-16 ft-lbs
rear tailhousing to trans body bolts: 24-33 ft-lbs
transfer case to tailhousing bolts: 30 ft-lbs
Trans mount bolts: 64-81 ft-lbs
Rear driveshaft flange yoke to transfer case bolts: 83
Driveshaft to driveshaft rear axle pinion flange bolts: 83
Front driveshaft to front axle bolts: 11-15
Driveshaft constant velocity joint to transfer case bolts: 22
starter bolts: 16-20 ft-lbs

 

[modest89]

Im pretty savvy with torques and that sounds about right! Thanks for your time and effort I really appreciate it. Your awesome!

 

[denniswpb]

Torque Specs for Body Mounts

Does anyone have the torque specifications for the 10 body mounts on a 2001 Explorer Sport? Thanks!!

 

[swshawaii]

Does anyone have the torque specifications for the 10 body mounts on a 2001 Explorer Sport?

Front radiator support mounts @ 41 ft/lbs.
Body mounts @ 59 ft/lbs. (8 total from A pillar back)

http://www.explorerforum.com/forums/showthread.php?t=213515

 

[denniswpb]

Thanks!!! I put new Daystar Body Mounts in about a year ago and the ones under the front floor pan are rattling like crazy. I torqued them pretty tight. Not real happy about the way they went in though. It seems like there is a lot of play in these two mounts that come with spacers. All the others seem fine.

Thanks again!