clutch drain plug

[dean.haley]

im trying to find the drain plug for my clutch on a 97' Ford explorer sport?
my clutch has no pressure at all and im tired of messing with it can you please help me?

 

[colintrax]

Most cars use a dry clutch, including your explorer. It's probably the slave, did you check the fluid level?

 

[RangerX]

There's a bleeder screw right next to where the hydraulic line goes into the side of the trans. Is that what you're looking for?

 

[renegade1]

look where the hydraulic line goes into the bellhousing. just above that is the bleed screw (itll be covered with a little rubber cap). the slave is inside the bellhousing on these trucks so hopefully you just need to bleed it. get some DOT3 brake fluid, a buddy, and an 8mm or 5/16th wrench. make sure the master is full (the reservoir is near the driverside fender/firewall) - have your buddy push the clutch in and hold it, open the bleed screw, shut the bleed screw, slowly let up the pedal, pump the pedal, and repeat about 5-10 times. every few cycles check to make sure the master stays full.