Search results

Hmmm.... That's an idea! Where is this valve you speak of located?

Ok so I got the truck to start (thanks everyone for your help!) but I'm back to the original issue. It starts up fine, runs fine, but when I turn it off it's dieseling (continues to try and run after the key is turned off) but not every time. When it does it, it will go on for 5-15 seconds...

Ok I checked the MAF (P.S. I had regular #2 Phillips screws on my MAF!?) and the wires were in tact. I cleaned it with brake cleaner and tried starting with and with out it plugged in and still no start. Now I know I heard the fuel pump wine when I would shut it off before, but I don't think I...

Wrong thread sorry

Thanks for the quick responses guys. The battery is brand new. About 2 weeks old. I have a multimeter I can try putting on it to see if the volts are ok. I checked and the terminal is good and tight on there. The air filter is brand new, but I was wondering if the MAF might be fouled up or bad...

Ok so yesterday after my drive into work I shut my truck off and it started dieseling (the engine kept trying to run after I turned the key off) and continued to do this through out the day. It ran fine when I drove it and it would start up alot faster that usual. A couple guys suggested that...

My manual trans shifter is REALLY loose and it's starting to be a little difficult to get it into the gears. Any suggestions on what to do about this? Can I rebuild the shifter or do I need to replace it and where can I order from?

Thanks for the link! That will def. come in handy. I pulled the door apart a couple days ago and was wondering how to get the motor out!

Thanks guys! I ran to autozone and got the gear bushings. I'm going to rebuild the motors this weeked so we'll see how it goes!

I apologize if this is a repeat post but, my front passanger side/rear drivers side windows have the same issue. You push the switch and you can hear the motor thumping in the door but the window wont go down. Sometimes it does but then it wont go back up without pulling it. Are the motors shot...