p0340

I have just recently noticed some rumbling and misfiring at high rpm. I had a p0340 code. I have a 98 5.0 with a t5. I have already replaced the cam position sensor and the alternator, but the code and its symptoms are still present . What’s my next step?

I have a 1997 Ford Aerostar with the 3.0L Vulcan engine, 86,000 miles. My check engine light is on, and it has the following error codes: P0340 - CMP sensor circuit fault P0340-C CMP sensor circuit malfunction I have an obd 2 cable, and I use obd 2 software called FORScan, so I can reset the...

I'm getting a P0340 code on my '99 F150 v6 4.6 liter engine. Reading these forums, I know that this isn't all that uncommon. I know Rock Auto has the part for about 16 bucks and if I replace it I will need an OTC 6469 Camshaft Sensor Synchronizer Tool and that it could also be the voltage...

Hello to everyone, I have a 1999 Ford Explorer 4.0 OHV. All stock. I've been having a sputter, jerk, hesitation while driving. Its not coming from the transmission. I hooked it to a OBII scanner and it is showing the following codes : P0135 , P0340 , P0175 . Is this my culprit of the issue i...

Yesterday my CE light came on. Code reader said P0340 and 1309. I cleared the codes, restarted the engine and the CE came on again but only the P0340. With the engine running I clear the codes the CE light stays off until I shut it down and restart at which time the CE/P0340 returns. I'm...

Has anyone replaced a "Camshaft Position Sensor" on a 5.0 liter (1997) AWD Explorer? I have the part; it looks like two screws are all it takes . . HOWEVER . . . there is alot of talk about bringing #1 cylinder to top-dead-center ("TDC") & the use of a special tool for the job (which I'm...

Ok, so over the past month or so, my cars ability to start has been slowly deteriorating :( to the point where it wont even start.... Got the code pulled and it came up with p0340 Camshaft postion sensor a bank 1 circuit malfunction Looked it up at autozone, found the part, and decided it was...