1350/1354 front yoke interchangeability

[mjlogan]

I have a BW 1350 fixed yoke tcase in my ranger. Need to know if a 1354 front yoke will work with it.

Apologize for the lame question but i blew it and ASSumed i could run a explorer front shaft and already had it shortened to fit. And TDS is 2 days away

I'll delete this lame thread as soon as i figure it out. Thanks in advance

 

[DB_1]

Actually that's a good question, wish I could help ya but i've never dealt with a 1350 case. I would have to think they both use 1310 joints so if that jives then that brings the spline count into question. Do you have both cases already? Try swapping out the yokes if you do.

We've got a good group going to TDS this weekend if you wanna hang with us, the more the merrier Check out the California Explorers forum here on the board:http://www.explorerforum.com/forums/showthread.php?t=203120

 

[mjlogan]

haha, right on. we'll look for ya!

My BW1350 uses a 26 spline 1210 u joint yoke (just pulled it off). I'm hoping i can run to the yard tomorrow and grab a yoke off a 1354, slap it on there and be good. Otherwise i'm gonna try my hand at shortening the stock shaft to work with my C5 swap.

heres a link to my build for my ranger. nothin special but it is a blast. say hi if you see me out there we'll be camping behind blowsand.

http://www.pirate4x4.com/forum/showthread.php?t=598217&highlight=cheap+ranger

 

[IZwack]

Yes I believe they do -- when I was first planning of swapping in a 1354, I ran into a few threads of people swapping out the front yoke of the 1350.

 

[DB_1]

haha, right on. we'll look for ya!

My BW1350 uses a 26 spline 1210 u joint yoke (just pulled it off).
say hi if you see me out there we'll be camping behind blowsand.

Only 1210 huh? Learn something new everyday lol.

I'll keep an eye out for ya, we should be at the vendors area Sat. morn. and head out for a run afterwards.

 

[mjlogan]

ended up working out. thanks for the help