1995 Explorer-Check Engine Light

[rgh96gt]

I have a 1995 Explorer, 4WD. The check engine light came on so I took it to Autozone and had them look up the codes. Here they are:

53 - TPS Sensor Circuit open or above maximum

95

39

I replaced the TPS sensor just now and I disconnected the battery and turned the lights on for about 10 minutes to clear the codes but the light came back on. I looked the other two codes up online but could not figure out anything from what I read. Any help would be appreciated.

 

[rgh96gt]

Well now the three original codes are gone but now it is saying the following codes:

13 dc motor did not move


32 egr positioner sensor below closed limit

Any help would be appreciated.

 

[Tbars4]

...This is what your codes should look like with a 95 Explorer, OBDII...
http://www.explorerforum.com/forums/showthread.php?t=228242

 

[MrShorty]

Actually a '95 is still EEC-IV/OBD-1 (or at least 95% of '95's are). However, a '95 should be outputting 3 digit codes, not 2 digit codes. I would suggest reviewing your instructions and the sticky threads in the EEC-IV forum, then repeat the test yourself (so you won't ever have to depend on the guys at Autozone again) and see what you get.

 

[Tbars4]

..I guess only the Rangers fall in the 5%...
http://www.explorerforum.com/forums/showthread.php?t=71655