A/c help

[RADD]

I am trying to get the a/c working . I have searched this site for all the help without asking. Now I am asking.

For starters, the EATC blend door motor is not there, it was not working so I removed it and did not replace it.
All new O-rings, new orifice tube, junk yard compressor of same style, it was re-charged with refrigerant this past week, relays is good, no blown fuses, held a vacuum and no leaks

There is absolutely NO power to any component of the A/C system under the hood. I was told that the EATC blend door motor not being there would not be a problem. What else should i look for?

Any suggestions would help!!

 

[SoHK_alumni]

Power for the a/c components comes from the dash hvac controls with the exception of primany power to the WOT/ac clutch relay.

Power from the switch goes to both the relay coil and PCM. The PCM has a switch in series with the two pressure switchs to cut off the ground to the clutch relay coil if the pressures go wrong or the PCM detects a wide open throttle.