Adv trac stays off abs light on

[kodiakattack12]

What's up guys I recently lifted my mountaineer and I just put a set off 33s on it about 2 months ago. Ever since I did that the abs light has been on and my traction control light stays on and in the message center it says adv trac cut off automatically as soon as I start to drive it. Has anyone had this problem before or know anything about what it could be? Any feedback would be great thanks guys!

 

[2Trux]

I would look to see if you broke/cut/disconnected any wheel speed sensor wires.

 

[kodiakattack12]

I just replaced the passenger wheel bearing like 5k miles ago and the lights were still on and I read that the hub bearing have new sensors In then so maybe it's the drivers side

 

[Limited02]

So the lights were on prior to you changing the hub bearing?

In my experience, I used cheaper replacement hubs and within a short time, the abs light could stay on all the time. Turned out the sensors that come with the cheap hubs are crap. Luckily I kept the originals off my old ones and when I replaced the sensor, all has been great.

 

[Danfromwis]

Go to advance auto have them check the Abs system with a code reader or check out your speed sensor wires all of them back one an the one on the master under the hood they can clear the code too might just be that simple did you just pray its not a AbS tone ring in the rear dif that broke thats allot of no good