Ejay11
Elite Explorer
- Joined
- September 20, 2021
- Messages
- 7
- Reaction score
- 3
- City, State
- Currituck
- Year, Model & Trim Level
- 94 4x4 EXP
I recently bought a 94 X and have the rotors and auto hubs at my home where as the vehicle is 60 miles away. I replaced the wheel bearings and have cleaned the old grease out of the hubs and the alum/plastic assembly with the spring around it and will be soaking these parts in ATF. My question is how do these hubs lock, it would seem that pushing or pulling while turning the 3 lobe piece which is above the female spline in the hub should lock the spline to the hub somehow. I understand how to check this when its back on the X but am curious if there is a way to bench check it.
Thanks
Ej
Thanks
Ej