PekingMan
Well-Known Member
- Joined
- May 31, 2000
- Messages
- 335
- Reaction score
- 0
- City, State
- Tempe, Arizona
- Year, Model & Trim Level
- 1993 XLT 4x4
OK, I'm trying to replace the rear Transfer case output seal since the back of my transfer case was covered with a crap load of oil. After marking the driveshaft and flange, I was able to get the 4 bolts off the rear flange of the differential. However, the 4 bolts that connect the driveshaft to to output yoke of the transfer case are another story. My air gun, even on setting 4, won't get these suckers off. I think it probably has to do with the fact that they are covered in oil but I'm not entirely sure. Has anyone had a similair problem or have any suggestions? Oh, and yes, I have used liqiud wrench and scraped off as much of the oil as I can.