Flywheel Spacer?

[ParkerRocker]

I had my flywheel machined. 20/1000". Should I get a new wheel or should I just space it out? I'm installing it with a spacer so I hope that's what you guys suggest...

 

[IZwack]

You shouldnt need a spacer (I didnt know spacers were even available). Two hundreths of an inch is almost insignificant compared to the stroke of the slave cylinder.

 

[Spdrcer34]

.020?

Where did you find a spacer that is .020? I'm thinking you didn't. And you might have problems getting the transmission to seat proplerly.

Ryan

 

[Anime]

As mentioned, you don't need a spacer for that amount of machining.

However, if you've taken enough material off a flywheel that it would need a spacer to work correctly....it's time for a new flywheel.