Hoagi
New Member
- Joined
- September 12, 2008
- Messages
- 4
- Reaction score
- 0
- City, State
- San Antonio, TX
- Year, Model & Trim Level
- 96 xlt
I replaced the heater core this summer, following suggestions found on this forum and a Haynes manual. I removed and replaced the dash. As I recall, the only issue at that time was an ABS light that was on. When I went to remove the instrument cluster, the vehicle rolled back and the driver's door that was partially opened, struck my truck and opened a little farther than designed to before I hit the brake.
After the mishap the power windows did not work. Neither did the speedometer, the wind shield wipers (front and back), inside lights nor the overhead temperature/direction display. I am sure the speedometer worked prior to the mishap and so did the power windows. I am fairly certain the interior lights and wipers worked. When I checked the power window switch I have no voltage on the light blue/black with the key on. When I check continuity btwn the light blue/black and the pins in the door harness it show continuity to two pins light blue/black and the red light blue. I suspect it is something other than the wires in the door and would like some pointers. GEM? ECM? Power acc relay? thanks ahead of time.
After the mishap the power windows did not work. Neither did the speedometer, the wind shield wipers (front and back), inside lights nor the overhead temperature/direction display. I am sure the speedometer worked prior to the mishap and so did the power windows. I am fairly certain the interior lights and wipers worked. When I checked the power window switch I have no voltage on the light blue/black with the key on. When I check continuity btwn the light blue/black and the pins in the door harness it show continuity to two pins light blue/black and the red light blue. I suspect it is something other than the wires in the door and would like some pointers. GEM? ECM? Power acc relay? thanks ahead of time.
