Explorer93RDB
Well-Known Member
- Joined
- February 22, 2007
- Messages
- 105
- Reaction score
- 0
- City, State
- Lakeland Florida
- Year, Model & Trim Level
- 92 Explorer EB 4X4
We put in a new clutch, pressure plate and throwout bearing.. in last week
just today tried to move the bronc.. the clutch pedal went to the floor. we dumped old fluid and added new clean fluid.. we could hold our finger on the output of the hose going to the slave cylinder and it would hold pressure. but hooking up the line and bleeding the air and it would be back to the building no pressure.. there is no fluid inside that could be leaking from the slave.. so does anyone have any Ideas what we might try.. and is the 89 all one unit and must be replaced as one ????
just today tried to move the bronc.. the clutch pedal went to the floor. we dumped old fluid and added new clean fluid.. we could hold our finger on the output of the hose going to the slave cylinder and it would hold pressure. but hooking up the line and bleeding the air and it would be back to the building no pressure.. there is no fluid inside that could be leaking from the slave.. so does anyone have any Ideas what we might try.. and is the 89 all one unit and must be replaced as one ????
